![]() The stitch length is adjusted by turning a knob above the logo however, there is no indication other than physically inspecting your work to determine your stitch length. The feed dogs can't be lowered but they can be covered by accessory plates. The downside of this 128 is that it sews only forward. ![]() The machine is 3/4 size and uses 15 X 1 needle. The spring that holds the bobbin winder follower against the heart-shaped cam is either broken or not connected properly and is on our to-do list. The male end of the cord was retained for the power input. After cutting off the multiple outlet, a 5-ft. In fact, the burr, by preventing consistent stitching, may be why the machine appears to have had little use.Ī new electrical cord was made by cutting a new 15-foot extension cord into two pieces. The burr, which was on the bobbin rear-end, was sanded off and the area polished resulting in perfect stitches. With both slide plates open, it was just a matter of continually rotating the wheel toward oneself and watching the thread being pulled over and around the shuttle. Knowing very little about its operation, Jim slowly rotated the balance hand wheel until the lower thread hung up. A small burr on the shuttle caused skipped stitches, bird-nests of thread in spots on the bottom of the fabric, puckering, etc. There were problems at first which we fiddled with for several weeks after bringing the machine home.
0 Comments
Leave a Reply. |